A. German S.E.W. Motor powers screw rod driven screen up / down position and drive motor for squeegee / flood travel. Provides high cycle speed with smooth mechanical movements, low noise and accuracy.
B. Rotating index tables are servo driven for fast and precise mechanical cycle. Standard tables include threaded insert holes to hold tooling / fixtures during printing. Custom-made tooling / fixtures are optional. Submit drawing to: email@example.com
C. Travel of squeegee / flood on guided precision sealed linear motion bearings, reinforced tooth belt, timing belt wheel for high rigidity and ultra-smooth high print speed transport cycles without backlash. This ultra-smooth gliding of the squeegee / flood assembly enables step-less speed change for higher production speed, smooth operation, consistent / uniform printing deposit control, less maintenance and fast operation.
D. Squeegee / flood high-park capability facilitates faster setup and changeover.
E. Patented mechanical print head lift guided on precision sealed linear motion bearings allows stable, vibration-free movement in up/down positions.
F. Includes pneumatic squeegee / flood pressure equalizer control system. Fully automatic and regulated by a constant pressure control system equalized with pivot point balance for angled substrate along with snowplow skew feature for irregular print surfaces.
G. Squeegee and flood printing parameter settings for speed, pressure, and stroke travel distance is independently controlled by single action from the touch screen.
H. Print table X / Y movements via precision scaled micrometer control(s) for fine registration. Play-free registration without backlash.
I. Touch screen control of off-contact height between substrate and screen. Numerical value can be set up to accommodate substrate thickness 0 – 50mm (0 – 2”).
J. Choice of three print functions from touch screen: flooding before the print stroke, flooding after the print stroke and double squeegee mode with use of two squeegees to perform left print direction while right squeegee is idle and right print direction while left squeegee is idle. Includes no flood setting and print head lift for ease of sq / fl load and unload without removing for fast setup.
K. Touch screen input of printing standby height 50-300mm. This is the distance that the screen lifts up after the squeegee and flood sequence. Numeric value can be preset to stop the screen in a lower position for increase cycle speed.
L. Squeegee / flood assembly is synchronized and changeover is pneumatically operated for smoother transition. Adjustable height controls, angle settings 0-30°, leveling and skew feature. Provides uniform ink deposits across the entire print area.
M. Touch screen input for variable and independent print and flood stroke speed and length setting to image size. Numerical input of right print stroke start point 0-140mm and left stop point 180-330mm.
N. Print operating cycles: Manual setting for set up procedure, setting for foot pedal control in single cycle and automatic control with dwell timer range of time selectable for substrate loading, auto-print and off-loading.
O. Productivity preset in numerical values for throughput can be changed anytime. Enter production quantity according to run length and during the run screen will indicate current yield until preset number of prints are achieved.
P. Index table speed setting range 3.5 – 20.93 RPM.
Q. Frame loading and unloading from the front of the machine to facilitate fast setup and changeovers.
R. Control system for compressed air supply is an oil free FRL unit to prevent oil mist pollution, applicable in clean room environment. Less air consumption, ½ HP air compressor is enough.
S. Front safety bar location on the print head, compliant with OSHA safety regulations.
T. AT-25PAD includes 3 squeegee holders and 3 flood coaters and AT-45PAD includes 4 squeegee holder and 3 flood coaters, sq. / fl clamps, squeegee rubber, pedal switch control, toolbox, tools and door key.
1. Custom-made tooling / fixtures are optional. Submit drawing to: firstname.lastname@example.org
2. At-45PAD can be fitted with vacuum index tables for flat substrates ranges 0-50 mm (0 – 2”).
3. Additional registration pins, anti-static equipment and dripless squeegee. Others available upon request.